Injecting Insulin – Patient Education PostCare Task Medical HD
Articles,  Blog

Injecting Insulin – Patient Education PostCare Task Medical HD

This program will demonstrate injecting insulin. The goal is to inject the insulin into the
subcutaneous tissue between the top layer of the skin, the dermis and the underlying
muscle layer. The only concentration of insulin available
in the United States is 100 units per milliliter. A milliliter is equal to a cubic centimeter.
All insulin syringes are graduated to match this concentration. Insulin syringes are available in various
volumes, for example: 3/10 cc, which would hold a maximum dose of 30 units, 1/2 cc to
hold a maximum dose of 50 units and 1 cc to hold a maximum dose of 100 units. Some insulins are cloudy suspensions. To ensure
uniform dispersion of the insulin in the cloudy suspension, roll the vial gently between your
hands. Avoid vigorous shaking, which will produce air bubbles or foam and interfere
with obtaining the accurate dose. Wipe off the top of the bottle with an alcohol
swab. Discard the swab. Pick up the syringe and remove the needle
cap. With the syringe held upright, pull the plunger back until the end of the plunger
is at the mark of your dose, which in this example is 20 units. There is
now air in the syringe. Check the insulin bottle to ensure you have
the correct type of insulin. With the insulin bottle held firmly on a counter
or tabletop, insert the needle through the rubber cap into the bottle. Push the plunger down so that the air goes
from the syringe into the bottle. Turn the bottle upside down so that the air
in it is at the top. With the tip of the needle kept in the liquid,
pull the plunger back to your dose. If any air bubbles are in the syringe, push the plunger
back in and draw up the dose again. Remove the syringe and needle from the bottle.
Do not let the needle touch anything else until it touches your skin for the injection. Wipe the skin of the chosen injection site
with an alcohol swab and let the skin dry. Pinch up the skin and put the needle fully
through the skin at an 80 to 90 degree angle and push the plunger down completely. Discard the syringe and attached needle into
a puncture-proof container and replace the container’s screw cap. Instead of a puncture-proof container you
can purchase a special “Sharps” container with a hinged lid to store your used syringes
and needles. “>
When your storage or “Sharps” container is 3/4 full, dispose of it according to the policies
of your local authorities. The recommended sites for insulin injections
are shown. Change the place of each injection by moving a couple of inches from the previous
site. By doing this, you can stay in one general
area for several days.

Leave a Reply

Your email address will not be published. Required fields are marked *